|
574-256-5001 or 1-800-832-5653
Control Products for Shot Peening and Blast Cleaning Processes |
||||
| Home | | About Us | | Contact Us | | Distributors | |
Sensors Wheel Type
| Sensors for wheel type machines use inductive metal sensing technology (also used in MagnaValves). The amount of metal flowing through the sensor is converted into a 0-5 Vdc signal. Adjustments for sensor gain are provided so that in-situ flow rate calibrations can be performed by the customer. Note: media flow sensor are dependant upon mounting location and therefore cannot be factory calibrated. Be sure to contemplate your annual re-certification requirements prior to using this equipment. | .jpg) |
| CPN | Model | Bore | Display |
|---|---|---|---|
| 999299 | 399-2.0  | 2.0 (50.8)) |
260P |
| 999242 | 399-2.5 | 2.5 (63.5) | |
| 999243 | 399-3.0 | 3.0 (76.2) | |
| 999244 | 399-4.0 | 3.95 (101) | |
| These sensors must use the model 260-P display to convert the flow signal (frequency 11.000 Khz) to a 0-10 Vdc format. | |||
| CPN | Model | Bore | Controller |
|---|---|---|---|
| 999344 | 599-24-1.25-.6 | 1.25 NAT | |
| 999349 | 599-24-3.0 | 3.03 (77) | |
| 999350 | 599-24-5.0 | 4.98 (127) | |
| 999301 | 599-5.0 | 4.98 (127) |  FC |
©2010 Electronics Incorporated - 56790 Magnetic Drive - Mishawaka, Indiana 46545
Phone: 574-256-5001 / 800-832-5653 - Fax: 574-256-5222
Phone: 574-256-5001 / 800-832-5653 - Fax: 574-256-5222